Split Sleeves are used together with Mandrels to permit a one-sided Cold Expansion operation whilst protecting the hole from damage. They can only be use once are available in -S, … Read More
Mandrel
by StephanyMandrels are made from tool steel which has been heat treated to endure the severe tensile and compressive stresses to which they are subjected. Extra hard Mandrels may be ordered … Read More
Flush Nosecap
by StephanyThe Flush Nosecap holds the Split Sleeve during the Cold Expansion process and transfers the reactive forces from the Puller Gun to the workpiece. It can be used with both … Read More
Extension Nosecap
by StephanyThe Extension Nosecap is usded when the access is limited. It holds the Split Sleeve during the Cold Expansion process and transfers the reactive forces from the Puller Gun to … Read More
Start Drill
by StephanyStart Drills are used to produce new holes where considerable amounts of material removal is required.
Start Reamer
by StephanyStart Reamers are used to make start holes where only a limited amount of stock removal is needed and make optimal holes for the subsequent Cold Expansion process.
Finish Reamer
by StephanyFinish Reamers are used to leave holes to final size holes prior to installing applicable fasteners.
Combination Gauge
by StephanyThe Combination Gauge ensures that the start hole is within specified tolerance with the go/no-go gauge and that the final holes lies within tolerance with the go gauge.
Mandrel Gauge
by StephanyThe Mandrel Gauge ensures that the mandrel has not been worn under tolerance.